Skip to main content
IS 8009-1 · immediate + consolidation + secondary

Foundation settlement calculator

Immediate, primary-consolidation and secondary settlement of a shallow foundation over a layered profile — IS 8009 (Part 1):1976, with 2:1 or Boussinesq stress spread and the Cl 9.5.2 rigidity factor.

Free · no signup · computed in your browser by the engine TerraBrains runs in the app.

Inputs

Illustrative inputs are loaded to demonstrate the method. Replace them with your measured project data before interpreting results.

Keep this calculation

Free here. In TerraBrains this result is saved to the project, carries its clause into a signed report your client can verify, and updates when the borehole does.

Log the borehole this came from — the TerraBrains field app on iPhone, iPad and Android works offline on site and syncs the SPT, samples and layers to the same project.

Worked examples — checked live

Each example comes from a published source. Its inputs run through the same engine as your calculation above; a ✓ means our value is inside the tolerance stated for that example. Load one to see it in the form.

1 × 2 m footing over normally consolidated clay — consolidation settlement

Source: Das, B.M., Principles of Foundation Engineering (Cengage), Example 7.10 — S_c = 46.5 mm

1/1 within tolerance

The 2.5 m clay is entered as 20 sub-layers so the stress increase is integrated through the layer rather than taken at one point.

QuantityPublishedOursΔWithin tolerance
Primary consolidation settlement S_c (mm)46.5045.941.19 %✓

Tolerance: ±1.5 % (Das averages Δσ over the clay by Simpson's rule on three points; the engine integrates Boussinesq through 20 sub-layers (−1.2 %).)

Questions engineers ask

Which layers contribute consolidation settlement?

Only layers marked “Consolidating”. For those, primary settlement uses the void ratio e₀, Cc, Cr and OCR, and secondary settlement uses Cα from the end-of-primary time to the design life. Immediate (elastic) settlement is computed for every layer from its E and ν.

How is the stress increase below the footing computed?

Choose the 2:1 load spread (the conservative textbook method) or Boussinesq integration (IS 8009-1 Cl 8.3.1). The stress increment and the initial effective overburden at each layer are listed in the layer table.

What does the rigidity factor do?

IS 8009-1 Cl 9.5.2 allows the settlement of a rigid foundation to be taken as 0.8 of the flexible-foundation value. Pick “Rigid” to apply it; the factor used is reported.

Can I see how settlement develops with time?

Enter a coefficient of consolidation cv. The calculator then reports t₅₀, t₉₀ and the settlement at the design time from Terzaghi 1-D theory (IS 8009-1 Cl 10), and plots settlement against time.

All ten calculators

Save it, sign it, keep it current.

A free account saves the result to a project with its PDF calculation sheet, and carries the clause into a signed report your client can verify. The same engines run 233 analyses and 47 lab tests inside. 14 days free, no card.